<strike id="p9xaj"><blockquote id="p9xaj"></blockquote></strike>

<progress id="p9xaj"><big id="p9xaj"></big></progress>
<th id="p9xaj"></th>
<span id="p9xaj"></span>
  • 
    
    <progress id="p9xaj"><pre id="p9xaj"></pre></progress>
    <span id="p9xaj"></span>

    <th id="p9xaj"></th>
    <button id="p9xaj"><object id="p9xaj"></object></button>
  • <dd id="p9xaj"></dd>

      <em id="p9xaj"><ruby id="p9xaj"><input id="p9xaj"></input></ruby></em>
      <dd id="p9xaj"><noscript id="p9xaj"></noscript></dd>

        <button id="p9xaj"><acronym id="p9xaj"></acronym></button>

      1. 設為主頁  加入收藏
         
        ·降噪(ANC)藍牙耳機方案/內置DSP音效處理單芯片藍牙音響方案  ·馬達驅動IC  ·2.1聲道單芯片D類功放IC  ·內置DC/DC升壓模塊的D類功放IC  ·同步DC-DC升壓IC  ·無線遙控方案
        當前位置:首頁->網站公告
        德州儀器2.7W 恒定輸出功率D 類放大器TPA2013/TPA2013D1
        文章來源: 更新時間:2010/3/23 14:11:00
        在線咨詢:
        給我發消息
        張代明 3003290139
        給我發消息
        鄢先輝 2850985542
        給我發消息
        張順平 3003262363
        13713728695
         

        TI的單片無濾波器D類音頻功率放大器TPA2013D1能為各種便攜式應用提供恒定輸出功率,如個人導航設備、PDA、移動電話、便攜式媒體播放器以及手持式游戲機等。

                由于結合了 2.7W 的 D 類放大器與集成式升壓轉換器,整體效率達到 85%,用戶播放音樂或打電話時的熱損耗很小,從而有助于延長電池使用壽命。本文介紹TPA2013D1 D類放大器的主要性能,方框圖,以及在數碼相機中的應用電路圖和TPA2013D1評估板的電路圖與所用的元器件.

                The TPA2013D1 is a high efficiency Class-D audio power amplifier with an integrated boost converter. It drives up to 2.7 W (10% THD+N) into a 4 ohm speaker. With 85% typical efficiency, the TPA2013D1 helps extend battery life when playing audio.

                The built-in boost converter generates the voltage rail for the Class-D amplifier. This provides a louder audio output than a stand-alone amplifier connected directly to the battery. It also maintains a consistent loudness, regardless of battery voltage. Additionally, the boost converter can be used to supply external devices.

                The TPA2013D1 has an integrated low pass filter to improve RF rejection and reduce out-of-band noise, increasing the signal to noise ratio (SNR). A built-in PLL synchronizes the boost converter and Class-D switching frequencies, thus eliminating beat frequencies and improving audio quality. All outputs are fully protected against shorts to ground, power supply, and output-to-output shorts.

                主要特性:

                High Efficiency Integrated Boost Converter (Over 90% Efficiency)
                2.2-W into an 8-ohm Load from a 3.6-V Supply
                2.7-W into an 4-ohm Load from a 3.6-V Supply
                Operates from 1.8 V to 5.5 V
                Efficient Class-D Prolongs Battery Life
                Independent Shutdown for Boost Converter and Class-D Amplifier
                Differential Inputs Reduce RF Common Noise
                Built-in INPUT Low Pass Filter Decreases RF and Out of Band Noise Sensitivity
                Synchronized Boost and Class-D Eliminates Beat Frequencies
                Thermal and Short-Circuit Protection
                Available in 2.275 mm x 2.275 mm 16-ball WCSP and 4 mm x 4 mm 20-Lead QFN Packages
                3 Selectable Gain Settings of 2 V/V, 6 V/V, and
                10 V/V
                APPLICATIONS
                Cell Phones
                PDA
                GPS
                Portable Electronics

        圖1.器件的功能方框圖

                                                   圖2.TPA2013D1和TPA2032D1組成立體聲放大器電路

                 Use the boost converter of the TPA2013D1 as a power supply for the flash LED of a digital still camera. Use a microprocessor or other device or synchronize the flash to shutter sound that typically comes from the speaker of a digital still camera. Figure 33 shows a typical circuit for this application. LEDs, switches, and other components will vary by application.


                                                                   圖3. 數碼相機的LED驅動器

                Bypass the boost converter to drive the Class-D amplifier directly from the battery. Place a Shottky diode between the SW pin and the VCCIN pin. Select a diode that has an average forward current rating of at least 1A, reverse breakdown voltage of 10 V or greater, and a forward voltage as small as possible. See Figure 34 for an example of a circuit designed to bypass the boost converter.

                Do not configure the circuit to bypass the boost converter if VDD is higher than VCC when the boost converter is enabled (SDb ≥ 1.3 V); VDD must be lower than VCC for proper operation. VDD may be set to any voltage within the recommended operating range when the boost converter is disabled (SDb ≤ 0.3V).

                Place a logic high on SDb to place the TPA2013D1 in boost mode. Place a logic low on SDb to place the TPA2013D1 in bypass mode.



                                                                                       圖4.旁路電路

                TPA2013D1EVM Schematic


                                                                    圖5. 評估板TPA2013D1EVM 電路圖

              下表是TPA2013D1EVM的元件列表:

         
         
         
            相關產品  
        CS8330(單節鋰電/12V適配器雙電源供電、內置升壓15W單聲道音頻功放IC)
        HT81293(單節雙節鋰電供電內置自適應動態升壓20W單聲道D類功放IC)
        HT328(30W立體聲/80W單聲道D類功放IC)
        CS83702(單節鋰電池3.7V供電內置升壓18W單聲道D類音頻功放IC)
        HT566(I2S數字輸入20W立體聲無電感閉環D類音頻功放IC)
        CS83785(單節鋰電池內置升壓2x10W雙聲道D類音頻功放IC)
        CS8676(擴頻功能、低空載電流、免輸出電感、2X20W雙聲道/40W單聲道D類音頻功放IC)
        CS83711(兩節鋰電池7.4V供電內置升壓2x16.5W雙聲道D類音頻功放IC)
        HT8320(無電感雙電荷自適應升壓、防破音功能D/AB類切換4.5W雙聲道音頻功放IC)
        HT8310(無電感升壓、防破音功能D/AB類切換5.2W單聲道音頻功放IC)
         
         
        ·藍牙音箱的音頻功放/升壓/充電管
        ·單節鋰電內置升壓音頻功放IC選型
        ·HT7179 12V升24V內置
        ·5V USB輸入、三節鋰電升壓型
        ·網絡主播聲卡專用耳機放大IC-H
         
        氮氧化物分析儀 PAM8908 HT97220 CS5080 MAX97220 HT8691 發電機組

        業務洽談:手機:13713728695(微信同號)   QQ:3003207580  EMAIL:panbo@szczkjgs.com   聯系人:潘波

        地址:深圳市寶安西鄉航城大道航城創新創業園A5棟307/309

        版權所有:深圳市永阜康科技有限公司  備案號:粵ICP備17113496號

        国产精品久久久久久无毒不卡_各种作爱视频_放荡人妻全记录1一19_a级a片少妇高潮喷水